英语翻译给水引入管与排水管的水平净距不得小于1m,平行敷设时两管的最小净距不得小于0.5m,交叉铺设时,垂直净距不得小于0.15.给水管应铺在排水管上面,如反之,给水管应加套管,起长度不得

Question

英语翻译
给水引入管与排水管的水平净距不得小于1m,平行敷设时两管的最小净距不得小于0.5m,交叉铺设时,垂直净距不得小于0.15.给水管应铺在排水管上面,如反之,给水管应加套管,起长度不得小于排水管管径的3倍.全数尺量检查
焊缝高度不得低于母材表面,焊缝与母材应圆滑过渡,焊缝及热影响区表面应无裂纹、未熔合、未焊透、加渣、弧坑和气孔等缺陷.
坡度的正负偏差不超过设计要求坡度值的1／3,坡向泄水装置
水平尺和尺量检查
坡度符合设计要求.

Answer 1

The water supply leads clean be apart from into the level of the tube and the drain pipe can not small in 1 m,the parallelism spreads to establish two tube of minimum clean be apart from can not small in 0.5 ms,cross build,perpendicular clean be apart from can not small in 0.15.The water pipe should spread on the drain pipe,such as contrarily,the water pipe should add a set of tube,rising length can not be small to take care of path in the drain pipe of 300%.The total amount Chinese foot quantity checks
焊'S sewing height cans not is low in the female material surface,the 焊 sews with female material should tactful transition,the 焊 sews and the heat influence area surface and should have no crack,don't the 熔 match,don't 焊 deeply,add friendly bore etc.blemish of the residue,弧 pit.
The plus or minus deviation of slope doesn't request a slope value over the design of 1/3,ascent to leak water device
Spirit level and Chinese foot measure a check
The slope meets a design request.