灯具翻译冷反射定向照明卤钨灯1，安装及使用灯具时，应切断电源。2，灯杯燃点时温度较高，所以必须安装在合适的灯具上，不得直接接触易燃物品，安装时应注意通风和散热良好。3，灯

Question

灯具翻译
冷反射定向照明 卤钨灯
1，安装及使用灯具时，应切断电源。
2，灯杯燃点时温度较高，所以必须安装在合适的灯具上，不得直接接触易燃物品，安装时应注意通风和散热良好。
3，灯杯工作时，不得用手接触灯杯或灯胆，以免烫伤。
4，每只灯的工作回路应装有保险丝，其中熔断电流不大于1A，如无法安装时应使用防护装置的灯具，以防止灯泡爆炸。否则。后果自负。
5，额定电压 12V 220V
6，额定功率 20W 35W 50W
7，灯头型号 G*5.3 G*4.0
8,生产日期 见箱内合格证
注意假冒 仿冒必究

Answer 1

The cold glint definite direction illuminates a 卤钨 light
1, install and use a lamp, should cut off power supply.
2, the light cup ignition point the temperature is higher, so have to install on the lamp of[with] accommodation, can not get in touch with the combustible article directly, should notice while install well ventilated and spread heat good.
3, When the light cup work, can not get in touch with the light cup or the light 胆 by hand, the in order to prevent burn.
4, the work back track of each light should have fuse, among them, the 熔 power failure flow to be no bigger than a 1 A, such as can't install should use the lamp of the protection device, in order to prevent the lamp bulb explosion.Otherwise.Result gasconade.
5, the sum settles an electric voltage 12 Vs 220 Vs
6, the sum settles a power 20 Ws 35 Ws 50 Ws
7, the socket model number G*5.3 Gs*4.0
8, produce date to see a qualified certificate inside the box
The attention counterfeits to imitate to emit to investigate necessarily