英语翻译实验采用发动机为K-0SPT型等离子体发动机,如图1所示：K0-SPT为200W脉冲态下小功率等离子体源,用于仪器在轨的校正和姿态保持,具有下列参数：外廓尺寸Ф=85mm,长43mm.加速管长L=20mm,

Question

英语翻译
实验采用发动机为K-0 SPT型等离子体发动机,如图1所示：
K0-SPT为200W脉冲态下小功率等离子体源,用于仪器在轨的校正和姿态保持,具有下列参数：外廓尺寸Ф=85 mm,长43 mm.加速管长L=20 mm,通道为11 mm.以陶瓷BN做电介质壁面.该模型中气体分布器和阳极均布在空间中.气体分布器在参数为L=15 mm,Ф=60 mm的缓冲区内.
模型由下列元件组成：如图3-1,(1)电介质加速管；(2)气体分布器；(3)阳极；(4)个励磁线圈；(5)磁导体；(6)后法兰底板.磁场利用采用铜铬铌合金耐热导线扰成的内外线圈产生的.一个线圈放置在外绝缘体(6)上面,另外两个放在中心绝缘体(4)内部缠绕在内铁心上.加速通道内的磁场是由这些励磁线圈和磁导体决定的,磁导体包括外部的凸缘和安在线圈上的铁心,其磁流的连接是依靠四个销来完成的.阴极固定在距发动机出口5~6 cm处.

Answer 1

Using engines for the K-0-SPT plasma engine,as shown in Figure 1 :K0 - SPT to 200W small pulse state power plasma source for the equipment in orbit correction and attitude to maintain,with the following parameters :size outer EF = 85 mm and 43 mm long.Accelerating tube length L = 20 mm,11 mm channel.BN ceramics do dielectric wall.The model for the distribution of gas and anodic uniform in space.Gas distribution parameters for the L = 15 mm,60 mm EF = buffer zone.Model consists of the following components :Figure 3 -1,(a) dielectric accelerating tube; (2) Gas Distribution; (3) anode; (4) Coil; (5) magnetic conductor; (6) After the floor flange.Magnetic field using niobium using copper - chromium alloy wire heat interference into the internal and external coil produced.A coil placed insulator (6) above,the other two at the center insulator (4),internal wound on the core.Channel accelerated by the magnetic field excitation of these coils and magnetic conductor decision,Magnetic Conductor including external flange and security in the core coil,the magnetic current on the link between four to complete the sale.Fixed cathode exports from Engine 5 6 cm.