英语翻译模具六大系统1：支撑系统在成型较大制品时,由于两模脚之间的跨度较大,在较高的注射压力下,公模板可能会发生弯曲变形,从而造成成型缺陷,为解决这一问题,就需增加支撑的东西,

Question

英语翻译
模具六大系统
1：支撑系统
在成型较大制品时,由于两模脚之间的跨度较大,在较高的注射压力下,公模板可能会发生弯曲变形,从而造成成型缺陷,为解决这一问题,就需增加支撑的东西,常见的有：
A.模脚 B.支撑柱(SP)
2：成型系统
用于成型,常见的有：
A、公、母模仁 B、滑块 C、斜销 D、入子
3：导向系统
为便顶出平衡,合模顺畅,通常使用一些导向定位的东西.常见的有：
1.导柱(导向公 、母模板) 2.顶板导柱(导向顶出板) 3.定位块 4.RP
4：顶出系统
A.顶出销 B.顶出块 C.套筒 D.剥料板 E.气体顶出
5：浇注系统
注塑机喷嘴中熔融的塑料,经过主流道、分流道,最后通过浇口进入模具型腔,然后经过冷却固化,得到所需成品.因此浇注系统主要包括以下三项：
A.主流道 B.分流道 C.浇口
6：温控系统

Answer 1

Six Die System
1:Support System
In forming the larger products,due to the two-mode foot span between the larger,at a high injection pressure,public template bending deformation may occur,resulting in forming defects,to solve this problem,there was a need to increase support things are common:
A.Mold feet B.supporting column (SP)
2:Prototyping System
For molding,common are:
A,the public and the mother die Ren B,slider C,oblique pin D,into the sub -
3:Guiding System
To be top of the balance,the smooth mold,usually using some of the things-oriented positioning.Common are:
1.Introduction column (public-oriented,the mother templates) 2.Roof Guides (Ejection-oriented board) 3.Positioning block 4.RP
4:Top of the system
A.Top of the top-selling B.block C.sleeve D.stripping plate E.Gas Ejection
5:Gating System
Injection molding machine nozzle in the molten plastic,through the mainstream Road,shunt,and finally through the gate into the mold cavity,and then after cooling solidification,get the finished product.Gating system is therefore mainly includes the following three:
A.mainstream Road B.shunt gate C.
6:Temperature Control System